SUPERSERVER
JLAN1/2 (Ethernet Ports)
Two Ethernet ports (designated JLAN1 and JLAN2) are located beside the VGA port on the I/O backplane. These ports accept RJ45 type cables.
Alarm Reset (JAR)
The system will notify you in the event of a power supply failure. This feature assumes that Supermicro redundant power supply units are installed in the chassis. Connect a microswitch to the JAR header to disable the power supply fail alarm. Note: this header is unused with the
Alarm Reset
Pin Definitions (JAR)
Pin# | Defi nition |
2+5V
1Ground
Compact Flash Card PWR Connector
ACompact Flash Card Power Connector is located at JWF1. For the Compact Flash Card to work properly, you will fi rst need to connect a power cable to JWF1 and correctly set the Compact Flash Jumper (JCF1).
SGPIO
The two headers labeled SGPIO1 and SGPIO2 are for SGPIO (Serial Gen- eral Purpose Input/Output). SGPIO provides a bus between the SAS/SATA controller and the SAS/SATA drive backplane to provide SAS/SATA en- closure management functions. Con- nect the appropriate cables from the backplane to the SGPIO1 and SGPIO2 headers to utilize SAS/SATA manage- ment functions on your system.
SGPIO Header
Pin Definitions (SGPIO1, SGPIO2)
Pin# | Defi nition | Pin # | Defi nition |
1 | NC | 2 | NC |
3 | Ground |
| Data |
4 | |||
5 | Load |
| Ground |
6 | |||
7 | NC |
| NC |
8 | |||
|
|
|
|
Note: NC indicates no connection.
