SUPERSERVER 6015B-Ni Manual
Figure 6-1. Chassis: Front and Rear Views
Control Panel
Drive Bays (behind bezel)
Keyboard Port Mouse Port | VGA Port Low Profile PCI Slot Standard PCI Slots | |
USB Ports | COM1 Port | Ethernet Ports |
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the JF1 connector on the serverboard to provide you with system status indications. A ribbon cable has bundled these wires together to simplify the connection. Connect the cable from JF1 on the serverboard to the appropriate header on the Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System Interface" for details on the LEDs and the control panel buttons. Details on JF2 can be found in "Chapter 5: Advanced Serverboard Installation."
