SUPER MICRO Computer H8QG6+-F, H8QGI+-F Memory Support, Maximum Memory, Top View of DDR3 Slot

Release Tab

Chapter 2: Installation

3.Gently press down on the memory module until it snaps into place.

4.With four CPUs installed, repeat step 2 to populate the CPU2 DIMM slots. Always install four DIMMs to both CPU DIMM slots for more efficient operation.

Note: 1 GB, 2 GB, 4 GB, 8 GB and 16 GB memory modules are supported. It is highly recommended that you remove the power cord from the system before installing or changing memory modules. Please refer to our web site for memory that has been tested on the H8QG6/i+-F serverboard.

Memory Support

The H8QG6/i+-F serverboard supports single/dual/tri/quad-channel, DDR3- 1333/1066/800 registered ECC/Unbuffered ECC/non-ECC SDRAM. Only interleaved memory is supported, so you must populate four DIMM slots at a time (see procedure below).

Populating four adjacent slots at a time with memory modules of the same size and type will result in interleaved (128-bit) memory, which is faster than non-interleaved (64-bit) memory.

Maximum Memory

The H8QG6/i+-F serverboard supports up to 512 GB of DDR3-1333/1066/800 registered ECC or 128GB of DDR3 Unbuffered ECC/non-ECC SDRAM.

Figure 2-1. DIMM Installation

To Install: Insert module vertically and press down until it snaps into place. Pay

Notch Notch

attention to the align- ment notch at the bottom.

To Remove: Use your thumbs to gen- tly push the release tabs near both ends of the module. This

Release Tab

Front View

Note: Notch should align with the receptive key point on the slot.

should release it from the slot.

Top View of DDR3 Slot

2-5