SUPER MICRO Computer X7SBL-LN1/LN2 user manual USB Wake-Up

Chapter 2: Installation

USB Wake-Up

Use JPUSB jumpers to enable the function of "System Wake-Up via USB devices", which al- lows you to "wake-up" the system by pressing a key on the USB keyboard or by clicking the USB mouse of your system. The JPUSB jumpers are used together with the USB Wake-Up function in the BIOS. Enable both the jumpers and the BIOS setting to allow the system to "wake-up via USB Devices". See the table on the right for jumper settings and jumper connections. (JPUSB1 is for Back Panel USB ports:0/1, and JPUSB2 is for Front Panel USB ports:2/3/4/5/6.)

Note: The default jumper setting for the USB ports located on the back panel is "Enabled". However, when the "USB Wake- Up" function is enabled in the BIOS and the desired USB ports are enabled via the JPUSB jumper, please be sure to remove all USB devices from the USB ports whose USB jumpers are set to "Disabled" before the system goes into the standby mode.

JPUSB2 (Front Panel USB

Wake-up)

Pin#	Defi nition
1-2	Enabled
2-3	Disabled (*default)

JPUSB1 (Back Panel USB

Wake-up)

Pin#	Defi nition
1-2	Enabled (*default)
2-3	Disabled

A. JPUSB1

B. JPUSB2

A

B

2-27