Sylvania 6727DG About Overlap of Programs, Timer Program Extension, To Cancel a Program

ABOUT OVERLAP OF PROGRAMS

When programs overlap, a program may not be recorded.

•The program with an earlier start has priority.

•Once the earliest program finishes, the overlapping pro- grams will begin recording in sequence.

•When the starting time is the same, the program set on the highest position in the program list has priority.

•The illustration below demonstrates the sequence of recordings.

Recording Sequence

Program 1 10:00AM-11:00AM Program 2 9:00AM-10:00AM Program 3 9:30AM-12:00PM

9:00AM 10:00AM 11:00AM 12:00PM

*Recording period is SHADED

TIMER PROGRAM EXTENSION

You can shift the time schedule of an automatic timer recording after programming or during recording.

1Press [POWER] to turn on the unit.

2Press [SET-UP].

Use [K / L] to select "TIMER PROGRAMMING", then press [ENTER].

3 Press [REC] and use		– TIMER PROGRAMMING –
[K / L] to select the desired		CH	DATE	BEGIN END
	B	61	7/03 MON 7 :30-PM- 8:50-PM- SP
program.	- -	- - - -	- /-- - - -	- :- - - - -	:- - - - - -
	- -	- - - -	- /-- - - -	- :- - - - -	:- - - - - -
	- -	- - - -	- /-- - - -	- :- - - - -	:- - - - - -
	- -	- - - -	- /-- - - -	- :- - - - -	:- - - - - -

4Press [REC] repeatedly until your desired begin/end time appears.

Each press will shift forward the begin/end time for recording by 10 minutes.

NOTES:

•When the recording is already in progress, each press will shift forward the end time only.

•If you want to cancel while setting, press [PAUSE F] on the remote control. The recording time returns to the original time.

•When you shift forward the time schedule during recording, the recording speed will be automatically set to the SLP mode.

5Press [ENTER] to complete the setting. Then press [SET-UP]to exit the menu.

TO CORRECT A PROGRAM AFTERWARD

1Press [POWER] to turn on the unit.

2Repeat steps 1 to 2 of "AUTOMATIC TIMER RECORDING" on page 28.

3Press [B] (or press [s] to go back one step) until the part you want to correct begins flashing, then use [K / L] to make the changes.

Press [ENTER] to confirm.

4Press [POWER] to set automatic timer recording.

TO CANCEL A PROGRAM

1Press [POWER] to turn on the unit.

2If recording is in progress, press [STOP/EJECT CA] on the unit.

3Press [SET-UP].

Use [K / L] to select "TIMER PROGRAMMING", then press [ENTER].

4Use [K / L] to select a program you want to cancel and press [CLEAR].

5Press [SET-UP]to exit the menu.

VCR SECTION

RECORDING

29

EN