Connections
STB connection to TV and Video devices (VCR, DVD recorder, etc)
e.g.: Connection to VCR
NOTE:
Audio cables and video cables are not included.
Rear panel of STB
To audio input jacks (L, R)
Audio cable
To video input | Video |
jack | cable |
Audio cable
VCR
Video cable
1Use a standard antenna cable to connect the wall jack to the ANT IN jack on STB.
2Use a standard audio cable to connect the set of audio output jacks (L, R) on STB to the set of audio input jacks (L, R) on the VCR.
NOTE:
If your VCR is monaural (MONO) and has only one audio jack, use a standard audio cable (white) to connect the audio output jack (white) on STB to the audio input jack (white) on the VCR. The red cable and jack will not be used.
3Use a standard video cable to connect the video output jack on STB to the video input jack on the VCR.
4Set the video resolution selection switch to “480i.”
NOTE:
No matter where the switch is, the video resolution with this connection will be always 480i. For screen ratio and display mode, the settings in Setup menu will be effective.
For the capability of your TV and further information, refer to TV owner’s manual.
5Use a standard video cable to connect the video output jack on the VCR to the video input jack on the TV.
6Use a standard audio cable to connect the set of audio output jacks (L, R) on the VCR to the audio input jacks (L, R) on the TV.
7Plug all AC power cords into AC outlets, then turn all devices on.
8Set the TV and VCR to input mode.
NOTE:
Refer to the owner’s manuals of the TV and the VCR for further information.
NOTE:
When using a standard video cable to connect, the resolution of the video signal output will always be 480i.
24
EN
