TacT Audio M/S - 2150 X TRIGGER INPUT: OFF OFF ON, DIGITAL GAIN 12 dB

33T act Audio
The gain menu is designed to select the amount of digital amplification applied to
audio signal. Digital gain can be set from 0 to 18.0 dB in increments of 0.1 dB.
These feature should be used in cases with low audio signal levels - CD’s that are
not fully modulated (do not cover full signal range). Increasing the amount of digital
gain does not increase M/S-2150 X output power . It will only give suf ficient boost to
the input signal so that it covers entire M/S-2150 X output power range.
1 - Active gain setting.
Gain Menu
1
GAIN menu
To set DIGITAL GAIN use UP and DOWN buttons. Selected gain is immediately
activated.
TRIG menu
TRIG Menu
The trigger menu is used to control the behavior of the M/S 2150 X amplifier when a
trigger signal is detected. When TRIGGER INPUT is set to ON and a trigger sig-
nal is detected the amplifier will turn ON. The amplifier will switch to STANDBY
mode if there is no trigger signal detected. When the input trigger is set to OFF
the unit will not respond to a trigger signal. However , the trigger signal will still be
passed through the Trigger OUT terminal on the rear panel.
TRIGGER INPUT: OFF
OFF ON
1 - Trigger input selections.
2 - Active trigger input setting.
2
1
DIGITAL GAIN
12 dB
Use LEFT and RIGHT buttons to highlight desired option and then press -
ENTER to select it.
Main Menu Options M/S-2150 X