7T act Audio
Unpacking the M/S-2150 X
Carefully remove the M/S-2150X and accessory kit from the carton and check for
shipping damage. Contact both the shipper and TacT Audio immediately if the unit
shows any sign of damage from rough handling. All TacT Audio equipment is carefully
inspected before leaving our factory .
KEEP SHIPPING CARTON AND PACKING MATERIALS for future use or in the
unlikely event that the unit needs servicing. If this unit is shipped without the original
packing, damage could occur and void the warranty.
You should find the following items in the accessory kit:
- one AC mains cord
- RJ1 1 data cable
- RJ1 1-to-RS232 adapter
- 15’ RS232 cable
- CD-rom with software
- remote control
- 2 AAA batteries
- one manual
The M/S-2150 X amplifier is configured for either 1 10 or 220/240 volt operation. The
operating voltage is clearly marked on the outside of the box and also on the rear
panel beneath the AC mains connector .
BEFORE CONNECTING THE POWER, MAKE SURE THA T THE LABEL INDICA T -
ING THE VOL TAGE MA TCHES THE VOL TAGE FOR YOUR COUNTRY
The M/S-2150 X has three operating modes:
- OFF AC mains power is cut off, either via the front
panel mains switch, or by unplugging the amplifier from
the wall outlet.
- ST ANDBY The unit is powered but all outputs are muted and the
display is off. The amplifier uses very little current and
is “idling” or “sleeping”. Use the remote “ST ANDBY”
button to toggle between ON and ST ANDBY.
- ON Everything is powered and ready to use.
Accessories
Operating voltage
M/S-2150 XUnpacking