2 Installation
11
2.1 Unpacking and Mounting Unpacking
To avoid damage to the unit during transportation the system is delivered as separate
components:
Cabinet
Top plate (when using two monitors)
High quality monitor (one or two, depending on configuration). XGA monitors are
optional.
Inside the cabinet you will find the accessories box which will contain the following:
W.A.V.E. II Camera
Table Microphone
Remote Control
Documentation
Mounting
Place the monitor on top of the cabinet/top plate and ensure it is stable.
You may fasten the monitor to the cabinet using the securing kit.
Take the camera and remove the plastic backing from the double sided tape-pads on
the base of the unit. Place the camera centrally, on top of the monitor close to the
front. If the system has two monitors, place the camera on the left monitor (where
menus and incoming picture will be displayed).
Note! The camera should be aligned with the front edge of the monitor to ensure that the
IR-sensor in the camera can pick up the signals from the remote control.