4 Administrator Settings
61
4.1.2 System Name
System Name identifies the system:
 on the welcome page.
 during an MCU conference call.
 when using the Web-interface.
 when the codec is acting as an SNMP Agent.
 towards a DHCP server.
 as an H323 ID. Other systems can call in using this name instead of IP-number/IP-
address.
System Name is blank by default. System name can be alphanumeric and up to 50
characters long. Follow the installation procedure to enter a System Name.
4.1.3 Dual Monitor
TANDBERG systems can be used with both one or two monitors. If you use two monitors,
make sure that Dual Monitor is set to On.
On Selfview, snapshots and Duo Video will be displayed on the second monitor.
Off The second monitor shows selfview only.
4.1.4 Autoanswer
The auto answer setting decides whether an incoming call is put through automatically or
manually.
On The system will automatically answer all incoming calls.
On+MicOff The system will automatically answer all incoming calls and switch the
microphone off when the call is connected. Press Mic Off to switch the
microphone on.
Off You must manually answer all incoming calls by pressing OK or the Call
key.