Tandberg Data LTO-2 HH Installation of Software Device Drivers, Mounting Screw Requirements

Tandberg Data Tape Drive Installation

3.3 Installation of Software Device Drivers

If the backup application software does not detect the tape drive, or obtain the latest operating system drivers and upgrades, please visit www.tandbergdata.com.

3.4 Mechanical Installation Internal Tape Drive

For mechanical mounting specifications, see Figure 3.2.

Allowed mounting position is either horizontal with the indicator LEDs to the right, or vertical with the indicator LEDs up (see Figure 3.1).

Figure 3.1 Allowed mounting orientations

The drive occupies a half-height 5.25-inch slot with mounting screws on both sides of the drive chassis or at the bottom of the drive.

Figure 3.2 Mounting specifications

3.5 Mounting Screw Requirements

•Only M3 (metric) screws must be used for mounting the drive

•	Maximum permitted screw penetration:	2.5 mm
•	Minimum required screw penetration:	2.0 mm
•	Screw torque, mounting screws:	0.5 Nm

•Screws are supplied with all the Tandberg LTO HH drive variants

• Bag with 4 screws and 4 SCSI-ID jumpers (Ordering no. 43 32 65)

6 Tandberg LTO HH Installation and User Manual