Configure menu
Choosing the option you want from the Configure menu
1.Press the SELECT button.
Note: if you make a mistake at any point, press the BACK button to go back to the previous screen.
2.Turn the TUNE knob until ‘Configure’ is displayed
3.Press the SELECT button.
4.Turn the TUNE knob until the display shows the option you want.
5.Press the SELECT button to choose the option shown on the display. The options are explained below.
<Network Config>
Enables you to scan again for connection to another wireless network, or to manually configure the network parameters. Use this if you take the Internet radio to another building where you want to use it
The Network Config menu also allows you to choose whether or not the Internet radio displays a warning message when its network signal strength is low. You can enable this feature by selecting ‘Signal Warning’ and then selecting ‘Yes’.
<Version>
Displays the versions numbers of the various parts of software and hardware on your Internet radio.
<Upgrade Firmware>
Use this option to download new firmware for the radio from the Reciva portal on the Internet. If there is new firmware available, then the radio will prompt you if you want to download it or not. Note, at this stage, you can press the radio’s BACK button to cancel the radio beginning a firmware upgrade. A Firmware upgrade may take several minutes, so do NOT switch off the power to the radio until the operation is complete otherwise the radio may become permanently damaged.
29
