2 – Advanced techniques
MOVE ® INSERT
This function takes the section of a track or tracks marked by the IN and OUT points, and moves it to the chosen track or tracks, inserting it as new material, starting at the TO point.
After the operation, the selected section of the source between the IN and OUT points is replaced by silence.
The insert operation adds the selected section as new material to the destination. Nothing is overwritten on the desti- nation, as any material following the TO point is moved to the end of the
IN | OUT | TO |
IN | OUT | TO | |||
|
|
|
|
|
|
|
|
|
|
|
|
You can change the following values:
SOURCE.TRK This sets the source track or tracks from which the section is taken. Choose 1 through 8 to select an individual track. Choose 1/2, 3/4, 5/6, 7/8 to select a pair of tracks. Choose
DESTINATION. TRK This sets the destination track or tracks into which the selected section is inserted. What you can select here depends on what you have selected for the source track. If you have selected a single track, you can select tracks 1 through 8 here. If you have selected a pair of tracks (for instance, 1/2), you can only select track pairs here. If you have selected all tracks
Press YES/ENTER to perform the operation or NO/EXIT to leave this screen.
OPEN
This function “opens up” a silent gap between the IN and OUT points on the chosen track or tracks.
The source and destination are the same, and after the operation, the track is split at the IN point, with the material which followed the IN point now moved to follow the OUT point. The result is therefore longer than the original.
IN OUT
IN OUT
There is only one value that you can change:
OPEN.TRK Select an individual track (1 through 8), a pair of tracks (1/2, 3/4, 5/6, 7/8), all of the tracks
Press YES/ENTER to perform the operation or NO/EXIT to leave this screen.
50 TASCAM