Tascam MD-801RMKII owner manual Resume setting, EOM track, EOM disc, Timer-controlledplayback

3 - Resume setting

The minimum length for the jog loop is 12 frames,
		R
and the maximum value is 32 frames. The value is set					NOTE
in 1-frame steps.				The EOM tally signal is always transmitted
				when the U-TOC is updated as the result of a
3.6 Resume setting				recording operation having been completed,
				unless this setting is set to off. It is also trans-
				mitted when recording is halted temporarily.
	RESUME SEL ?
When the resume setting is turned on, playback
			3.8 EOM track
restarts from the point at which it was stopped (or the
point at which playback was taking place when the
power was cut off). The default is off, which means
					EOM TRACK ?
that when playback is stopped, it will start at the
			The EOM track is similar to the EOM disc function,
beginning of the disc, unless a track number is
explicitly specified.			as described above. The EOM tally signal is trans-
This function, when on, changes the function of the			mitted before the end of a track playback, and this
			menu allows the time before the end to be set, or the
STOP key [5]. When the resume function is on, and
			disabling of this function (default off).
the STOP key is pressed in play mode, the MD-801
enters play ready mode. If the STOP key is pressed			When this message is transmitted, the E O M indicator
once again, the MD-801 enters stop mode.			flashes in the display.
After the menu has been opened with the SHUTTLE			After the menu has been opened with the SHUTTLE
wheel, the display changes:			wheel, the display changes:

RESUME> OFF

The options available are on and off.

EOM TRK> OFF

The time may be set from 1 to 99 seconds, in 1 sec- ond steps, or set to off.

3.7 EOM disc

EOM DISC ?

This menu item affects the output of the MD-801 to a device attached to the parallel port (see 7.1, "REMOTE (PARALLEL) connector". When set on, an “EOM DISC” tally signal is transmitted from the parallel port when the end of the disc is reached in playback (or recording, in the case of the MD-801R).

When this message is transmitted, the E O M indicator flashes in the display.

In this menu, it is possible to select how many sec- onds before the end of the disc this message is to be sent, or to turn the message off completely. The default setting is off.

After the menu has been opened with the SHUTTLE wheel, the display changes:

EOM DISC>OFF

The time may be set from 1 to 99 seconds, in 1 sec- ond steps, or set to off.

3.9 Timer-controlled playback

TIMER PLAY ?

When this function is enabled, if a disc is in the unit, and the unit is powered up (e.g. from a timer-based switching unit), the TOC is read, and playback starts. The default setting is off.

If the resume function is switched on (3.6, "Resume setting") playback will start from the point at which playback was last stopped, or at the playback point at which the power was last cut off.

If the resume function is off, playback will start from the beginning of the disc.

After the menu has been opened with the SHUTTLE wheel, the display changes:

TMR PLY>OFF

The options available are on and off.

3–2TASCAM MD-801R/P Mk II