Tascam VL-A4/VL-A5, VL-A8/LF-S8 3-NAMESAND FUNCTIONS00

3-NAMES AND FUNCTIONS00

LF-S8 Rear Panel Front Panel

1POWER switch

This is used to turn the power on and off.

2FUSE holder

This unit is equipped with a fuse. lf the unit does not work, disconnect the power plug from the AC outlet and then contact the nearest qualified service personnel.

3~ IN jack

This ~ IN jack is used to connect the supplied power cord.

4INPUT CH1/CH2 jacks

These balanced input jacks suit for both XLR balanced and TRS PHONE balanced connectors, and are typically connected to output jacks on a mixer.

5CROSS FREQ knob

This control is used to set a cutoff frequency between 40 to 120 Hz to cut high or low frequency output from the subwoofer.

6OUTPUT CH1/CH2 jacks

These output jacks connect XLR balanced connectors. High frequency signals are output through the jack (low- frequency is cut according to the cutoff frequency set with the CROSS FREQ knob). An external device such as a power amplifier is connected to the jack.

When you use the LF-S8 with the VL-A4, VL-A5 or VL-A8, connect both the left (CH1) and right (CH2) INPUT jacks.

7OUTPUT SUB LF jack

This output jack connects XLR balanced connector. Low frequency signals are output through the jack (high fre- quency is cut according to the cutoff frequency set with the CROSS FREQ knob). The second subwoofer is con- nected to this jack.

8LEVEL CONTROL knob

This is used to adjust the output level of the subwoofer speaker.

9PHASE switch (0°/180°)

This is used to switch the output phase of the subwoofer speaker. Depending on speaker placement, or the com- bination of speaker systems, bass sounds may be heard differently. If so, try to adjust the output phase using this switch to make bass sounds better for you.

0POWER indicator

This indicator lights up when the power switch is turned on and AC power is supplied to the ~ IN jack.

ENGLISH

TASCAM VL-A's 9