14
Operating Procedures Model104
Align the hole in the draw arm over the stem on the
freezer door and push down. Make sure the draw arm
fits into the depression in the draw plate.
Figure 13
Screw the stem cap over the stem that protrudes f rom
the draw arm. Once snug, tighten one step further to
align the hole in the cap.
Figure 14
Secure the cap with the clevis pin.
Figure 15
Engage drip spout pins with corresponding holes on
the back side of the freezer door.
Figure 16
Step 6
Position the door onto the two studs on the f ront of the
freezing cylinder. Make sure the hole in the back of the
door is aligned with the bearing on the end of the
beater.
Figure 17
Install the two handscrews onto the studs and tight en
equally.
Figure 18