Taylor 104 - page 24

Operating Procedures Model104

Step 4

Thoroughly brush clean all disassembled parts in the

cleaningsolut ion, making sure all lubricant and mix film

is removed. Place the cleaned parts on a clean dry

surfacetoairdry.

Step 5

Return to the freezer with a small amount of cleaning

solution. With the black bristle brush,brush clean the

rear shell bearing at the back of the freezingc ylinder.

Figure 33

Step 6

Wipe clean the exterior surfaces of the freez er.

Contents

Main Page Table of Contents Table of Contents -- Page 2 Section 1 To the Installer Installer Safety S Site Preparation Air Cooled Units Electrical Connections S 60 Cycle Units Beater Rotation Refrigerant Section 2 To the Operator Compressor Warranty Disclaimer Section 3 Safety S Section 4 Operator Parts Identification Model 104 Beater Door Assembly Accessories Section 5 Important: To The Operator Control Switch (Item 1) Orange Dial Light (Item 2) Safety Timer Control (Item 3) Door Hinge (Item 4) Reset Condition Section 6 Operating Procedures Assembly Page Page Sanitizing Priming Overrun Drawing Product Rinsing Cleaning Disassembly Brush Cleaning Page Section 7 Important: Operator Checklist During Cleaning and Sanitizing Troubleshooting Bacterial Count Regular Maintenance Checks Winter Storage Section 8 Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY PAG E REF. Section 9 Parts Replacement Schedule Section 10 Warranty Explanation Section 11 Parts List