14 Models H62 & H63Important: Tothe Operator
Operating Screen Descriptions
Whenthe m achine is powered the system will initialize.
The screen will display “INITIALIZING ”. There will be
four types of data the system will check: LANGUAGE ,
SYSTEM DATA, CONFIG DATA, and LOCKOUT
DATA. During the INITIALIZING... LANGUAGE
screen, the alarm will be on. If the system data,
configuration data, or lockout history data has bec ome
corrupt, the following screen will alert theoperator that
the system settings may have been changed.
NVRAM FAULT
RESET TO DEFAULTS
PRESS SEL KEY
Once the system has initialized the SAFETY
TIMEOUT screen is displayed and thealarm is turned
on.
SAFETY TIMEOUT
ANY KEY ABORTS
This screen will be displayed, with the alarm on, f or 60
seconds or until any key is pressed.
After the safety timeout has been complet ed, and the
power switch is OFF, one of the following screens is
displayed.
The first screen is displayed if the machine is not in a
brush clean state.
POWER SWITCH OFF
MIX: OUT TIME:4:30
HOPPER: 62.1
BARREL: 67.7
If any of the requirements f or a brush clean have not
been met, the time displayed will remain at 5:00
minutes. When all the requirements for a brus h
cleaning are met, and the five minutes expire, the
screen will change to the second screen, which is the
standard power switch OFF screen.
POWER SWITCH OFF
-- = -- = -- = -- = -- = --
UNIT CLEANED
When the power switch is set in the ON position, the
system mode of operation screen is displayed. In this
example, the machine is ON, but no mode of operation
has been selected. The second line of the display
indicates whether there is a sufficient supply of mix in
the hopper or if there is aLOW or OUT mixcondition.
The third line of the display shows the temperatur e of
the mix hopper. After pressing the AUTOkey, the last
line of the display shows the month and date (MM =
month, DD = day) that the machine needs to be
disassembled and brush cleaned.
MODE: ON
MIX: OK
HOPPER TEMP: 40.0F
BRUSH CLEAN ON: MM/DD
The next display indicates the freezer is operating in
two different modes. The following information is
given:
The machine is operating in the WASH mode and the
mix level in the hopper is low. The temperature ofthe
mix hopper is 40_F(4.4_C),and the machine needs to
be brush cleaned on October 31st.
MODE: WASH
MIX: LOW
HOPPER TEMP: 40.0 F
BRUSH CLEAN ON: 10/31