18 Models H62 & H63Important: Tothe Operator
091210
Clearing Fault Tones
To clear the tone for any faults which have been
corrected, press the <-- --arr ow key.To see if there is
more than one fault, press the MENU/SEL key.When
the last fault is displayed, the cont rol will return to the
OPERATOR MENU. To return to the main screen,
move the cursor to “A” and press the MENU/ SEL key
again.
Listed below are the variable messages which will
appear, along with the corrective action:
1. NO FAULT FOUND: There was no fault found
in the freezer. Nothing will appear on the screen
after this variable message appears.
2. BEATER OVERLO AD: Press the reset button
firmly and clear the tone .
3. HPCO COMPRESSOR: Place the power
switch in the OFF position. Wait 5 minutes for
the machine to cool. Place the power switch in
the ON position and clear the tone.
4. COM P ON TOO LONG: Place the power
switch in the OFF position and clear the tone.
Call service technician.
5. HOPPER THERM BAD: Place the power
switch in the OFF position. Call service
technician.
6. BARRE L THERM BAD: Place the power
switch in the OFF position. Call service
technician.
7. GLYCOL THERM BAD: Place the power
switch in the OFF position. Call service
technician.
8. HOPPER OVER TEMP: The hopper
temperature has risen too high as follows. Clear
the tone.
a. The hopper temperature was 41_F(5_C) or
higher for four hours.
b. The hopper temperature was 45_F(7_C) or
higher for more than one hour.
9. BARRE L OVER TEMP: The barrel temperature
has risen too high as follows. Clear the tone.
a. The bar relt emperature was 41_F(5_C) or
higher for four hours.
b. The barrel temperature was 45_F(7_C)or
higher for more than one hour.
10. PO WER FAILURE: This message will appear
in the FAULT DESCRIPTION if a power failure
has occurred. Clear the tone.
Screen “C” is SET CLOCK. This screen will display the
current date and time. The date and time may onlybe
changed after the freezer has been manually brush
cleaned but before it has been placed in the AUTO
mode. Move the cursor under the number you wishto
change. Press the plus key to increase the number;
press the minus key to decrease the number. When
the desired time and date appears, press the
MENU/SEL key once to return t o the OPERATOR
MENU.
SET CLOCK
10:21 AM 12/07/2009
-- --
<------ ------> +++ ------ SEL
If an invalid date is entered, the following screen will
appear.
SET CLOCK
10:34 AM 02/30/2010
-- -- I N V A L I D DA T E
<------ ------> +++ ------ SEL
When the MENU/SEL key is pressed, the controller
will return to the previous LCD screen to allow for
correction of the calendar entry. The controller will not
advance to the next screen until a valid date has been
entered. Once a valid date has been entered, pressing
the MENU/SEL key will display a the Daylight Saving
Time screen.
DAYLIGHTSAVING TIME
ENABLE DISABLE
_____
<--------> SEL
Pressing the <-- -- arrow key or t he -- --> arrow key
will move the cursor left or right r espectively.Pr essing