29
Models H62 & H63 Operating Procedures
110527
Step 7
Return to the freezer with a small amount of cleaning
solution. Dip the end brush into the cleaning solution
andbr ush clean the door spout and bottom of the draw
valve.
Note: To assure sanitary conditions are maintained,
brush each item for a total of 60 seconds, r epeatedly
dipping the brush in cleaning solution.
Step 8
Rinse a single service towel in cleaning solution and
wipe down the freezer door and area around the
bottom of the freezer door.
Step 9
Rotate the draw valve bracket to the right to disengage
it from the draw arm before entering a heat cycle.
Note: Oncet he heating cycle has started, it cannot be
interrupted. The heating cycle will take a maximum of
four hours to complete.
DO NOT draw product or attempt to
disassemble the unit duri ng the HEAT cycle. The
product is hot.
When the heating cycle is complete, the control will
return to the STANDBY mode.
There are three phases of the heat cycle; Heating,
Holding and Cooling. Each phase has a time limit. If
any one of the three phases fails to reach the proper
temperatures within the time limit, the cycle will
automatically abort and return to the STANDBY mode.
The LCD will display the message “HEAT TREAT
CYCLE FAILURE -- FREEZER LOCKED -- PRESS
SEL KEY”. The product may not be safe to serve. The
freezer will be locked out of the AUTO mode. Discard
the product and brush clean the machine.
Daily Opening Procedures
Evaluate the condition of LED’s (lights) and screen
messages (Hard Lock or Soft Lock, etc.) before
performing the Opening Procedures. As indicated in
the illustration below, four flashing LED’s indicate a
“locked” condition.
Figure 29
MAKE SURE YOUR HANDS ARE CLEAN
AND SANITIZED BEFORE PERFORMING T HESE
NEXT STEPS.
Step 1
When the heating cycle is complete, the normal dis-
play will appear, showing the machine in the
STANDBY mode.
Step 2
Rotate the draw valve bracket to the left to engage t he
draw arm.
Step 3
Prepare a small amount of an approved 100 PPM san-
itizing solution (examples: Kay--5Ror Stera--
SheenR). USE WARM WATERAND FOLLOW THE
MANUFACTURER’S SPECIFICATIONS.
Step 4
Sanitize the front drip tray and splash shield in the
sanitizing solution.