27
Models H62 & H63 Operating Procedures
091210
Step 7
Once the sanitizer stops flowing from the dispensing
spout, close the draw valve and press the WASH key,
cancelling the beater motor operation.
Figure 24
MAKE SURE YOUR HANDS ARE CLEAN
AND SANITIZED BEFORE PERFORMING T HE
NEXT STEP.
Step 8
Place the agitator on the agitator housing.
Figure 25
Note: If the agitator stops turning during normal
operation, place the unit in the OFF mode. Remove the
agitator from the agitator housing and brush clean
these parts with sanitizing solution. Inst all the agitator
back onto the agitator housing and place the unit in the
ON mode. Be sure your hands are san itized when
performing this step.
Priming
Note: If a powdered or concentrated mix will beused,
follow the manufacturer’s mix preparationinstructions
before placing the mix in the mix hopper. DO NOT
attempt to mix theproduct in the hopper!
Step 1
Place a mix pail beneath the door spout and open the
draw valve. Fill the hopper with FRESH mix and allow
it to flow into the freezing cylinder. This will for ce out
any remaining sanitizing solution. When full strengt h
product is flowing from the door spout, closethe draw
valve. Open the prime plug by turning it
counterclockwise until the air in the freez ing cylinder is
allowed to escape.
Figure 26
Step 2
When product rises to the bleed port, c lose the prime
plug by turning it clockwise until it is snug against the
freezer door.
Step 3
Press the AUTO key. When the unit cycles off, the
product will be ready to serve.
Figure 27