32 Models H62 & H63Operating Procedures
110531
Rinsing
Step 1
Pour two gallons (7.6 liters) of cool, clean water into
the mix hopper. With the brushes provided, scrubt he
mix hopper, mix level sensing probes, the outside of
the agitator housing, and the mix inlet hole.
Figure 36
Step 2
With a mix pail beneath the door spout, press the
WASH key.
Figure 37
Step 3
Open the draw valve on the freezer door. Drain all the
rinse water from the door spout, close the draw valv e,
and press the WASH key cancelling the wash cycle.
Figure 38
Repeat this procedure until the rinse water being
drawn from the freezing cylinder is clear.
Hopper Cleaning
Step 1
Prepare a pail of an approved 100 PPM cleaning solu-
tion (examples: 2--1/2 gal. [9.5 liters] of Kay--5Ror
2 gal. [7.6 liters] of Stera--SheenR).USE WARMWA-
TER AND FOLLOW THE MANUFACTURER’S SPE-
CIFICATIONS.
Step 2
Pour the cleaning solution into the hopper and allow it
to flow into the freezing cylinder.
Step 3
While the solution is flowing into the freezing cylinder,
brush clean the mix hopper, mix level sensing probes,
the outside of the agitator housing, andmix inlet hole.