6
Safety Model 432
131202
Anequipot ential grounding lug is provided with this
unit. Some countries require the grounding lug be
properly attached to the rear of the frame by the
authorized installer. The installation location is marked
by the equipotential bonding symbol (5021 of IEC
60417-1) on both the removable panel and the unit’s
frame.
DO NOT use a water jet to clean or r inse the
unit. Failure to follow these instructions may result in
serious electrical shock.
SDO NOT allow untrained personnel to
operate this machine.
SDO NOT operate the freezer unless all
service panels and access doors are
restrained with screws.
SDO NOT remove any internal operating
parts (examples: freezer door, beater,
scraper blades, etc.) unless all control
switches are in the OFF position.
Failuret o follow these instructions may result in severe
personal injury to fingers or hands from hazardous
moving parts.
This unit has many sharp edges that can
cause severe injuries.
SDO NOT put objects or fingers in the door
spout. This may contaminate the product
and cause severe personal injury from blade
contact.
SUSE EXTREME CAUTION when removing
the beater asssembly. The scraper blades
are very sharp.
This unit must be placed on a level surface.
Extreme care should be taken when moving the unit
for any reason. Two or more persons are required to
safely move this unit. Failure to comply may result in
personal injury or damage to the unit.
Access to the service ar ea of the unit must be
restricted to persons having knowledge and practical
experience with the unit, in particular as far as s afety
and hygiene are concerned.
Cleaning and sanitizing schedules are
governed by your state or local regulatory agencies
and must be followed accordingly. Please refer to t he
cleaning section of this Operator Manual for the proper
procedure to clean this unit.
This unit is designed to maintain pr oduct
temperature under 41_F(5_C). Any product being
added to this unit must be below 41_F(5_C). Failure
to follow this instruction may result in healt h hazards
and poor freezer performance.
DO NOT obstruct air intake and discharge openings:
A minimum of 6” (152 mm) on both sides and 0” ont he
back is required. Failure to follow this instruction may
cause poor freezer performance and damage to the
machine.
ForIndoor Use Only: This unit is designed to operate
indoors, under normal ambient temperatures of 70_-
75_F(21_-24_C). T he freezer has successfully
performed in high ambient temperatures of
104_(40_C) at reduced capacities.
DO NOT run the unit without product. Failure to follow
this instruction can result in damage to the unit.
NOISE LEVEL: Airborne noise emission does not
exceed 78 dB(A) when measured at a distance of 1.0
meter from the surface of the machine and at a height
of 1.6 meters from the floor.