19
Model 432 Operating Procedu res
140814
Step 3
If local health codes permi tth e use of rerun,place
a sanitized, NSF approved stainless steel rerun
container beneath the door spout. Place the power
switch in the “WASH” position and move the draw
handle to the right. When all the product stops flowing
from the door spout, move the draw handle t o the left
and place the power switch in the “OFF” pos ition.
Place the sanitized lid on the rerun c ontainer and place
it in the walk- in cooler.
Note: Iflocal health codes DO NOTpermit the use
ofrerun, the product must be discarded. Follow the
instructions in the previous step, except drain the
product into a pail and properly discard the mix.
ALWAYSFOLLOW LOCAL HEALTH CODES.
Repeat these steps for the other sid e of the unit.
Rinsing
Step 1
Pourt wogallons ( 7.6 liters) of cool, clean water into the
mix hopper. With the brushes provided, s crub the mix
hopper and the mix inlet hole.
Figure 29
Step 2
With a pail beneath the door spout, place t he power
switch in the “WASH” position and move the draw
handle to the right. Drain all the rinse water from the
freezing cylinder. When the rinse water stops f lowing
from the door spout, move the draw handle t o the left
and place the control switch in the “OFF” position.
Repeat this procedure until the rinse water being
drawn from the freezing cylinder is clear.
Repeat these steps for the other sid e of the unit.
Cleaning
Step 1
Prepare an approved 100 PPM cleaning solution
(examples: 2- 1/2 gal. [9.5 liters] of Kay- 5Ror 2
gal. [7.6 liters] of Stera- SheenR). USE WARM
WATER AND FOLLOW THE MANUFACTURER’S
SPECIFICATIONS.
Step 2
Pour the cleaning solution into the hopper and allow it
to flow into the freezing cylinder.
Step 3
While the solution is flowing into the freezing cylinder,
brush- clean the mix hopper and mix inlet hole.
Step 4
Place the power switch in the “WASH” posit ion. This
will agitate the cleaning solution in the f reezing
cylinder.
Step 5
Place an empty pail beneath the door spout and move
the draw handle to the right. Draw off all the cleaning
solution. When the solution stops flowing from the door
spout, move the draw handle to the left, and place the
power switch in the “OFF” position.
Repeat these steps for the other sid e of the unit.
Disassembly
Step 1
BE SURE THE CONTROL SWITCH IS IN THE
“OFF” POSITION.
Step 2
Remove the handscrews, freezer door, beater
assembly, torque rotor, scraper blade and drive shaft
from the freezing cylinder. Taket hese parts to the sink
for cleaning.
Step 3
Remove the front drip tray and the splash shield.Take
these parts to the sink for cleaning.
Step 4
Remove the rear drip pans from the front panel. Note:
If the drip pans are filled with an excessive am ount of
mix, it is an indication the drive shaft seals should be
replaced or properly lubricated.
Repeat these steps for the other sid e of the unit.