Taylor shake/slush freezer

Operating Procedures Model 432

Step 7

Position the torque arm by inserting it throught he slot

in the torque switch arm and down into the hole in the

torque rotor which protrudes from the door. Verify

proper installation by moving the torque rotor back and

forth to be sure it moves freely and easily.

Figure 18

Step 8

Install the front drip pans. Slide the long drip pans into

the holes in the front panel.

Figure 19

Step 9

Install the front drip tray and splash shield beneath the

door spouts.

Figure 20

Step 10

Lay the air/mix feed tube (optional) in the bottom ofthe

mix hopper.

Figure 21

Repeat these steps for the other sid e of the unit.

Contents

Main Page Table of Contents Table of Contents - Page 2 Section 1 To the Installer Installer Safety S Site Preparation Air Cooled Units Electrical Connections S Beater Rotation Refrigerant Section 2 To the Operator Compressor Warrant y Disclaimer Section 3 Safety S 7 Model 432 Operator Parts Identification Section 4 Operator Parts Identification Model 432 Figure 1 Page 9 Model 432 Operator Parts Identification Beater Door Assembly Parts Identification Accessories Section 5 Important: To the Operator Control Switch (Item 1) Push- Button Switch (Item 2) Display Light Switch (Item 3) Indicator Light - Mix Out (Item 4) Indicator Light - Add Mix (Item 5) Viscosity Adjustment (Item 6) Section 6 Operating Procedures Assembly Page Page Page Sanitizing Priming Closing Procedure S S S S Draining Product From The Freezing Cylinder Rinsing Cleaning Disassembly Brush Cleaning Section 7 Important: Operator Checklist During Cleaning and Sanitizing: Troubleshooting Bacterial Count: Regular Maintenance Checks: Winter Storage Section 8 Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY PA GE REF. Section 9 Parts Replacement Schedule Section 10 Limited Warranty on Equipment TaylorCompany Section 11 Limited Warranty on Parts Page TaylorCompany Section 12 Parts List CLASS REMARKS PARTS NUMBER QTY. WARR. DESCRIPTION PART Model 432 Parts List Page Page Page Page 052145-27 STATE COMPONENTS. SEE TABLE 1 TABLE 1 (REQUIRES OPTIONAL DOOR SWITCH) NO 052145-33 STATE COMPONENTS. FIG. 1 (REQUIRES OPTIONAL DOOR SWITCH) NO J2 PINS 5&6 4-DAY LOCKOUT ENABLE-INSTALL JUMPER TO ENABLE. 052145-40 STATE COMPONENTS. TABLE 1 (REQUIRES OPTIONAL DOOR SWITCH) NO J2 PINS 5&6 4-DAY LOCKOUT ENABLE-INSTALL JUMPER TO ENABLE.