Taylor shake/slush freezer Sanitizing

17

Model 432 Operating Procedu res

140814

Sanitizing

Step 1

Prepare an approved 100 PPM sanitizing solution

(examples: 2- 1/2 gal. [9.5 liters] of Kay- 5Ror 2

gal. [7.6 liters] of Stera- SheenR). USE WARM

WATER AND FOLLOW THE MANUFACTURER’S

SPECIFICATIONS.

Step 2

Pour the sanitizing solution into the hopper and allow

it to flow into the freezing cylinder.

Figure 22

Step 3

While the solution is flowing into the freezing cylinder,

brush clean the mix hopper, air/mix feed tube

(optional) and mix inlet hole.

Step 4

Place the power switch in the “WASH” posit ion. This

will agitate the sanitizing solution in the freezing

cylinder. Allow the solution to agitate for five minut es.

Figure 23

Step 5

Place an empty pail beneath the door spout and move

the draw handle to the right. Draw off all the sanit izing

solution. When the sanitizer stops flowing from the

door spout, move the draw handleto the left and place

the control switch in the “OFF” position.

Figure 24

Step 6

Stand the air/mix feed tube (optional) in the corner of

the hopper.

Figure 25

Repeat these steps for the other sid e of the unit.

Contents

Main Page Table of Contents Table of Contents - Page 2 Section 1 To the Installer Installer Safety S Site Preparation Air Cooled Units Electrical Connections S Beater Rotation Refrigerant Section 2 To the Operator Compressor Warrant y Disclaimer Section 3 Safety S 7 Model 432 Operator Parts Identification Section 4 Operator Parts Identification Model 432 Figure 1 Page 9 Model 432 Operator Parts Identification Beater Door Assembly Parts Identification Accessories Section 5 Important: To the Operator Control Switch (Item 1) Push- Button Switch (Item 2) Display Light Switch (Item 3) Indicator Light - Mix Out (Item 4) Indicator Light - Add Mix (Item 5) Viscosity Adjustment (Item 6) Section 6 Operating Procedures Assembly Page Page Page Sanitizing Priming Closing Procedure S S S S Draining Product From The Freezing Cylinder Rinsing Cleaning Disassembly Brush Cleaning Section 7 Important: Operator Checklist During Cleaning and Sanitizing: Troubleshooting Bacterial Count: Regular Maintenance Checks: Winter Storage Section 8 Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY PA GE REF. Section 9 Parts Replacement Schedule Section 10 Limited Warranty on Equipment TaylorCompany Section 11 Limited Warranty on Parts Page TaylorCompany Section 12 Parts List CLASS REMARKS PARTS NUMBER QTY. WARR. DESCRIPTION PART Model 432 Parts List Page Page Page Page 052145-27 STATE COMPONENTS. SEE TABLE 1 TABLE 1 (REQUIRES OPTIONAL DOOR SWITCH) NO 052145-33 STATE COMPONENTS. FIG. 1 (REQUIRES OPTIONAL DOOR SWITCH) NO J2 PINS 5&6 4-DAY LOCKOUT ENABLE-INSTALL JUMPER TO ENABLE. 052145-40 STATE COMPONENTS. TABLE 1 (REQUIRES OPTIONAL DOOR SWITCH) NO J2 PINS 5&6 4-DAY LOCKOUT ENABLE-INSTALL JUMPER TO ENABLE.