Taylor shake/slush freezer - page 18

14

Operating Procedures Model 432

Holding the beater securely, slide the beater into the

freezing cylinder and align the hole at the rear of t he

beater with the flats on the end of the drive shaft .

Slide the beater the remainder of the way into the

freezing cylinder and over the end of the drive shaft.

The beater assembly will not prot rude beyond the front

of the freezing cylinder.

Figure 8

Step 3

Install the white plastic guide bearing on the short end

of the torque rotor. Slide the o- ring into t he groove on

the long end of the torque rotor and lubricate the

o- ring. Do not lubricate the guide bearing.

Figure 9

Step 4

Insert the torque rotor end with the guide bearing into

the pilot hole in the center of the drive shaft. T he hole

in the torque rotor shaft should be rotat ed to the 12

o’clock position.

Figure 10

Step 5

Assemble the freezer door with the “Ice Bust er”( door

spout clearing device). To assemble the door with the

ice buster, install the o- rings on the draw valve and

lubricate.

Figure 11

Insert the draw valve into the door, leaving

approximately half of the valve sticking out the top of

the door.

Figure 12

Contents

Main Page Table of Contents Table of Contents - Page 2 Section 1 To the Installer Installer Safety S Site Preparation Air Cooled Units Electrical Connections S Beater Rotation Refrigerant Section 2 To the Operator Compressor Warrant y Disclaimer Section 3 Safety S 7 Model 432 Operator Parts Identification Section 4 Operator Parts Identification Model 432 Figure 1 Page 9 Model 432 Operator Parts Identification Beater Door Assembly Parts Identification Accessories Section 5 Important: To the Operator Control Switch (Item 1) Push- Button Switch (Item 2) Display Light Switch (Item 3) Indicator Light - Mix Out (Item 4) Indicator Light - Add Mix (Item 5) Viscosity Adjustment (Item 6) Section 6 Operating Procedures Assembly Page Page Page Sanitizing Priming Closing Procedure S S S S Draining Product From The Freezing Cylinder Rinsing Cleaning Disassembly Brush Cleaning Section 7 Important: Operator Checklist During Cleaning and Sanitizing: Troubleshooting Bacterial Count: Regular Maintenance Checks: Winter Storage Section 8 Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY PA GE REF. Section 9 Parts Replacement Schedule Section 10 Limited Warranty on Equipment TaylorCompany Section 11 Limited Warranty on Parts Page TaylorCompany Section 12 Parts List CLASS REMARKS PARTS NUMBER QTY. WARR. DESCRIPTION PART Model 432 Parts List Page Page Page Page 052145-27 STATE COMPONENTS. SEE TABLE 1 TABLE 1 (REQUIRES OPTIONAL DOOR SWITCH) NO 052145-33 STATE COMPONENTS. FIG. 1 (REQUIRES OPTIONAL DOOR SWITCH) NO J2 PINS 5&6 4-DAY LOCKOUT ENABLE-INSTALL JUMPER TO ENABLE. 052145-40 STATE COMPONENTS. TABLE 1 (REQUIRES OPTIONAL DOOR SWITCH) NO J2 PINS 5&6 4-DAY LOCKOUT ENABLE-INSTALL JUMPER TO ENABLE.