Taylor shake/slush freezer - page 19

15

Model 432 Operating Procedu res

Rotatethe drawvalve so the flats on the top of thedraw

valve are perpendicular to the door face.

Figure 13

Insert the ice buster through the door spout and into

the slot located just above the lower o- ring.

Figure 14

With the ice buster in place, rotat e the draw valve to

allow installation of the draw handle. This will lock the

ice buster in place. Install the draw handle pin, and

close the draw valve by moving the handle to the left .

Figure 15

Place the large rubber gasket into the groove on the

back side of the freezer door. Slide the white, plastic

front bearing onto the bearing hub, making cert ain that

the flanged end of the bearing is resting against the

freezer door. DO NOT lubricate the door gasket or

front bearing.

Figure 16

Step 6

Install the door on the four studs on t he front of the

freezing cylinder. Install the four handscrews on the

door, and tighten them equally in a criss- c ross

manner.

Figure 17

Contents

Main Page Table of Contents Table of Contents - Page 2 Section 1 To the Installer Installer Safety S Site Preparation Air Cooled Units Electrical Connections S Beater Rotation Refrigerant Section 2 To the Operator Compressor Warrant y Disclaimer Section 3 Safety S 7 Model 432 Operator Parts Identification Section 4 Operator Parts Identification Model 432 Figure 1 Page 9 Model 432 Operator Parts Identification Beater Door Assembly Parts Identification Accessories Section 5 Important: To the Operator Control Switch (Item 1) Push- Button Switch (Item 2) Display Light Switch (Item 3) Indicator Light - Mix Out (Item 4) Indicator Light - Add Mix (Item 5) Viscosity Adjustment (Item 6) Section 6 Operating Procedures Assembly Page Page Page Sanitizing Priming Closing Procedure S S S S Draining Product From The Freezing Cylinder Rinsing Cleaning Disassembly Brush Cleaning Section 7 Important: Operator Checklist During Cleaning and Sanitizing: Troubleshooting Bacterial Count: Regular Maintenance Checks: Winter Storage Section 8 Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY PA GE REF. Section 9 Parts Replacement Schedule Section 10 Limited Warranty on Equipment TaylorCompany Section 11 Limited Warranty on Parts Page TaylorCompany Section 12 Parts List CLASS REMARKS PARTS NUMBER QTY. WARR. DESCRIPTION PART Model 432 Parts List Page Page Page Page 052145-27 STATE COMPONENTS. SEE TABLE 1 TABLE 1 (REQUIRES OPTIONAL DOOR SWITCH) NO 052145-33 STATE COMPONENTS. FIG. 1 (REQUIRES OPTIONAL DOOR SWITCH) NO J2 PINS 5&6 4-DAY LOCKOUT ENABLE-INSTALL JUMPER TO ENABLE. 052145-40 STATE COMPONENTS. TABLE 1 (REQUIRES OPTIONAL DOOR SWITCH) NO J2 PINS 5&6 4-DAY LOCKOUT ENABLE-INSTALL JUMPER TO ENABLE.