Manuals / Brands / Kitchen Appliance / Blender / Taylor / Kitchen Appliance / Blender

Taylor shake/slush freezer Section 5 Important: To the Operator

1 42

Download 42 pages, 1.15 Mb

11

Model 432 Important:To the Operator

Section 5 Important: To the Operator

Figure 4

Item Description

1Switch- Toggle - 3 PDT

2Switch- Push Button - SPST

3Switch- Toggle-SPST - 3/4HP/250 V

4Light- Amber- Rect. - 12 VDC - MIX OUT

5Light- Amber- Rect. - 12 VDC - ADD MIX

6 Viscosity Adjustment

The following chart identifies the symbol definitions

used on the operator switches.

= The “ON/AUTO” button.

= The “OFF” button.

= The “WASH” button.

Control Switch (Item 1)

The center position is “OFF”. The left position is

“WASH”, which activates only the beater motor. The

right position is “AUTO”, which activates the beater

motor and the refrigeration system.

Push- Button Switch (Item 2)

If an overload condition occurs, the freezer will

automatically stop operating. To properly reset the

freezer, place the toggle switch in the “OF F” position.

Wait two or three minutes; then press thepush- button

switch. Place the power switch in the “WASH” position

and observe the freezer’s performance. Plac e the

power switch in the “AUTO” position.

Note: If the freezer is unplugged from the wall

receptacle, it will be necessary to press the

push- button switch for the freezer to operate once

power is r e- established.

Display Light Switch (Item 3)

The display light switch is located under the control

channel. The left position is “OFF”. The right position

is “ON”, and activates the display light.

Contents

Main Page Table of Contents Table of Contents - Page 2 Section 1 To the Installer Installer Safety S Site Preparation Air Cooled Units Electrical Connections S Beater Rotation Refrigerant Section 2 To the Operator Compressor Warrant y Disclaimer Section 3 Safety S 7 Model 432 Operator Parts Identification Section 4 Operator Parts Identification Model 432 Figure 1 Page 9 Model 432 Operator Parts Identification Beater Door Assembly Parts Identification Accessories Section 5 Important: To the Operator Control Switch (Item 1) Push- Button Switch (Item 2) Display Light Switch (Item 3) Indicator Light - Mix Out (Item 4) Indicator Light - Add Mix (Item 5) Viscosity Adjustment (Item 6) Section 6 Operating Procedures Assembly Page Page Page Sanitizing Priming Closing Procedure S S S S Draining Product From The Freezing Cylinder Rinsing Cleaning Disassembly Brush Cleaning Section 7 Important: Operator Checklist During Cleaning and Sanitizing: Troubleshooting Bacterial Count: Regular Maintenance Checks: Winter Storage Section 8 Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY PA GE REF. Section 9 Parts Replacement Schedule Section 10 Limited Warranty on Equipment TaylorCompany Section 11 Limited Warranty on Parts Page TaylorCompany Section 12 Parts List CLASS REMARKS PARTS NUMBER QTY. WARR. DESCRIPTION PART Model 432 Parts List Page Page Page Page 052145-27 STATE COMPONENTS. SEE TABLE 1 TABLE 1 (REQUIRES OPTIONAL DOOR SWITCH) NO 052145-33 STATE COMPONENTS. FIG. 1 (REQUIRES OPTIONAL DOOR SWITCH) NO J2 PINS 5&6 4-DAY LOCKOUT ENABLE-INSTALL JUMPER TO ENABLE. 052145-40 STATE COMPONENTS. TABLE 1 (REQUIRES OPTIONAL DOOR SWITCH) NO J2 PINS 5&6 4-DAY LOCKOUT ENABLE-INSTALL JUMPER TO ENABLE.