24
TroubleshootingGuide Model 432
PROBLEM PROBABLE CAUSE REMEDY PA GEREF.
4. Product too thick. a. Inadequate mix in hopper. a. Fill hopper with mix. 18
b. Improper mixing of
product.
b. Carefully follow directions
for mixing product.
---
c. The viscosity adjustm ent
is set incorrectly.
c. Adjust the viscosity
control.
11
d. The torque arm is not
installed.
d. Install the torque arm. 16
5. Product too thin. a. Missing, incorrectly
installed, or bad scraper
blade.
a. Install or replace scraper
blade.
13
b. Improper mixing of
product.
b. Carefully follow directions
for mixing product.
---
c. The viscosity adjustm ent
is set incorrectly.
c. Adjust accordingly. 11
d. Incorrect beater rotation.
(Rotation must be
clockwise.)
d. Contact service
technician.
---
e. Dirty condensers. e. Clean regular ly. 21
6. Scored walls of freezing
cylinder.
a. Broken pin on beater
assembly.
a. Repair or replace beater
assembly.
---
b. Front bearing worn or
missing.
b. Replace or install front
bearing.
14
7. Excessiveleakage into
rear drip pan.
a. Improper or inadequate
lubrication of drive shaft
seal.
a. Use correct lubricant
(Taylor Lube) and follow
lubrication procedures.
13
b. Bad or missing seal on
drive shaft.
b. Replace seal every 3
months.
25
c. Worn rear shell bearing. c. Contact service technician
for replacement.
---
8. Excessive leakage from
door spout.
a. Improper or inadequate
lubrication of draw valve
o-rings.
a. Use correct lubricant
(Taylor Lube) and follow
lubrication procedures.
13
b. Bad or missing o-rings on
draw valve.
b. Replace o-rings every 3
months.
25
9. Unable to remove drive
shaft.
a. Lubrication on square end
of drive shaft.
a. Do not lubricate square
end. Contact service
technician for
replacement.
13
b. Rounded corners of drive
shaft, drive coupling, or
both.
b. Contact service technician
to replace drive shaft,
drive coupling, or both.
---