TC electronic SDN BHD G-Natural user manual Menu Pedal

MENU - PEDAL

Pedal

Basics

•Press MENU to access

•Select Pedal using encoder D

•Press MENU to confirm

•Set values using encoders A, B and C

•Change pages using encoder D

•Confirm selection by pressing MENU if <menu> flashes in the right side of the display

•Exit by pressing MENU again

For external control of certain parameters you can connect an expression* pedal.

In this menu you assign which parameters to assign, calibrate G-Natural to the connected expression pedal and also dial in a response curve using the min, mid and max parameters.

Parameters marked with “P”

Some of the parameters in this menu are global parameters and some are saved at preset level. Parameters saved with each preset are marked with “p” in the right side of the display.

Example:

PEDAL MENU <menu> Map Param.: DLY DELAY P

*Best result is achieved using a regular expression pedal with a linear potentiometer. However, you may also achieve satisfying results using a regular volume pedal.

Connecting Expression pedals

Depending on the type of expression pedal used, the pedal should be connected using either a regular mono 1/4" jack-to-jack cable or a stereo 1/4" jack-to-jack cable.

Mono

Stereo

If you are not sure which type to use, you may have to try both types. G-Natural measures the signal on your expression pedals output connector. Therefore only one cable should be used per expression pedal.

Map Parameter

Assigning parameters to the pedal connected to the “Pedal Input”

PEDAL MENU <menu> Map Param.: DLY DELAY P

•Select a parameter to control from the list

•Press MENU to confirm

•Set Min Mid Max

Min - Mid - Max

Range: 0-100%

These settings determine the parameter response according to an expression pedal connected to the Pedal input. Values can be set for both the minimum, mid and maximum position of the pedal.

17