FRONT PANEL
POWER key | SYNC | TRIG |
On/Off switch for the unit. | Indicates the current clock of | Indicates when the Envelope | |
INPUT LEVEL knob | the TRIPLE•C. When locked to | function is processing the | |
an external clock, the "DI" icon | incoming signal. | ||
Adjusts the Input level. | is lit and the incoming Sample | LIMIT | |
Range is | Rate is displayed by either the | ||
INPUT/OUTPUT meters | 44.1 or 48 icon. | When the LIMIT LED is lit the | |
If no or unacceptable clock is | Envelope Softclipper is active. | ||
Peak meter showing Input and | available, the "Digital" and "DI" | ||
Output level. The meter range is: | icons will be blinking. | ||
0, | LINK indicator | Turns the | |
For the Stereo version this meter | on/off i.e. activates the full | ||
is common for both channels. | Indicates that the unit is linked | band mode. When the LED is lit | |
INPUT OVERLOAD LED | to a second TRIPLE•C. | the | |
MIDI | PEAK SENSITIVE key | ||
The OVERLOAD LED indicates | |||
one of two situations: The Input | When MIDI information is | The TRIPLE•C is basically an | |
level is too hot and therefore over- | received the MIDI icon will | RMS based Compressor, mean- | |
loading or there is an internal DSP | blink. | ing that it responds to average | |
overflow. The OVERLOAD LED is | Gain Metering | level of the incoming source | |
lit when 1 sample is @ 0dBFS. | material. This key turns the | ||
OUTPUT OVERLOAD LED | The Gain meter indicates the | TRIPLE•C into a Peak based | |
total gain through the TRIPLE•C | Compressor. When the LED is | ||
Indicates that the Output is too | and simultaneously shows the | lit the TRIPLE•C is in Peak | |
hot. This will occur if e.g. too | gain reduction. | mode. This feature is only | |
much gain has been added | Envelope Section | available in | |
through the TRIPLE•C. | SOFTLIM key | ||
The OVERLOAD LED is lit when | Indicates the setting of the | ||
1 sample is @ 0dBFS. | Envelope Mode. Please see | Activates/deactivates the Soft- | |
INPUT - Analog/Digital | Envelope chapter in the | Limiter in the Output section | |
manual for further information. | When the LED is lit, the Soft- | ||
Indicates whether the TRIPLE•C is |
| Limiter is active. | |
set to analog or digital Input. |
|
| |
When set to digital Input, the |
|
| |
Sample Rate automatically |
|
| |
switches to DI. In case of no or |
|
| |
unacceptable clock the "Digital" |
|
| |
and "DI" icon will be blinking. |
|
|
6
