Use

Programming a recording VCR

Your video recorder has eight programming memories. Thus, you will be able to programme eight recordings over a 1-year period.

Load a tape and position it to the desired section using the REV., FWD, STOP and PLAY keys.

Programming using a PlusCode® number

Each televised broadcast has its own PlusCode number guide which can be found in your TV magazine. To programme the recording of a broadcast, all that is required is for you to enter this number in the VIDEO Plus+ menu; it contains the date, start and end time and the number of the channel broadcasting the programme.

1Call up the VIDEO Plus+ menu using the PROG. key.

2Enter the PlusCode number of the programme using the number keys.

3Confirm using OK.

The TIMER menu comes up.

You may complete your programming by choosing daily or weekly repetition, double length or VPS- or PDC-signal triggered recording.

When programming for the first time, the cursor positions itself on Prog. number; confirm or enter the desired programme number.

4Press the OK key.

5Leave the menu using the EXIT key.

6Put the video recorder in standby mode using the B key.

The symbol on the display of the VCR confirms that your programming was successful.

VIDEO Plus+ and PlusCode are registered trademarks of Gemstar Development Corporation.

The VIDEO Plus+ system is manufactured under licence from Gemstar Development Corporation.

Storage of the programme numbers with the VIDEO Plus+ feature

The video recorder automatically stores the correspondance between channel numbers and PlusCode numbers so that you do not have to re-enter for each programming the channel number corresponding to the PlusCode programming number .

This is to say that the first time you programme a recording on a channel using the VIDEO Plus+ feature, the video recorder will prompt you to confirm or enter the channel number. When programming your next VIDEO Plus+ recording, the video recorder will automatically identify the channel concerned.

VIDEO PLUS+ system and satellite demodulator

If you use the PlusCode numbers to record a programme broadcast by satellite, the VIDEO Plus+ programmer can ask you to confirm the channel number (Pr99 / AV1 / AV2).

16

Page 16
Image 16
Technicolor - Thomson DTH 6000 manual Programming a recording VCR, Programming using a PlusCode number