TechniSat DIGIT MF4-S manual Current satellite list, Addressing a satellite position

The test transponder you have set will now check whether a signal can be received at this position. The system will also check whether the position to be saved is identical to a position available in the pre-programmed satellite position list. (Fig. 9-14)

If this is the case, the following message will be

displayed:Orbitalposition xx found. Save satellite ? (Fig. 9-15)

>To save the satellite position, use the arrow keys left/right to mark the field Yes, then confirm by pressing

OK.

If on checking the test transponder does not identify a pre- programmed satellite position, or if the signal received is too weak, a corresponding message will be displayed. (Figs. 9- 16 and 9-17)

>To save the satellite position, use the arrow keys left/right to mark the field Yes, and confirm by pressing

OK.

9.4 Current satellite list

The satellite positions saved are included in the satellite list. Positions not yet saved are marked in the list with a “*”.

>To turn the dish to a position included in the satellite list, use the arrow keys to mark the field Current satellite list.

>Confirm by pressing OK.

>Use the arrow keys up/down to select the desired position.

>Confirm by pressing OK.

The dish will now be turned to the position selected. The rotating procedure will be indicated by the blinking display “turn” in the menu.

9.4.1 Addressing a satellite position

To turn the antenna to the position set in your satellite list, your digital receiver is equipped with the function turn to sat.

>Press the yellow function key Actions to open the window showing the available actions.

>Now use the arrow keys up/down to mark the line turn to sat.

>Confirm by pressing OK.

>Press the green function key (turn to sat) to turn the antenna to the satellite position selected.

(Fig. 9-14)

(Fig. 9-15)

(Fig. 9-16)

(Fig. 9-17)

61