Tektronix 1740A/1750A STANDARD, For, Table, Using the Menus, Valid FORMAT selections

Using the Menus

	Table 3-1.	Valid FORMAT selections.
	FORMAT		BARS[1]		SETUP [2]
525/60			75%	100%	Y	N
	GBR		•	•		•
	SMPTE / EBU		•	•		•
	BETA		•	•	•	•
	MII		•	•	•
625/50			75% 100%		Y	N
	GBR		•	•		•
	SMPTE / EBU		•	•		•
	BETA		•	•		•
	MII[3]		•	•		•

[1]75% or 100% Bars selected through CONFIG—VECTOR menu.

[2]Setup Yes or No is selected through the CONFIG—VECTOR menu. The setup selection is only relevant with 525/60 BETA,

and is ignored in all other formats.

[3]

MII is identical to SMPTE/EBU in 625/50.

STANDARD

HCONFIG—STANDARDallows the user to set the cursor unit of measure to MV, IRE, or AUTO. When AUTO is selected, cursor units are automatically changed to IRE when operating in the NTSC standard, and MV when operating in the PAL standard.

HFor dual-standard instruments, a menu selection of NTSC, PAL, or AUTO standard is also available. When AUTO is selected, the operating standard is changes automatically to match the standard of the displayed input signal. A circled “A” precedes NTSC or PAL on the readout.

3-20 1740A/1750A Series Waveform/Vector Monitor User Manual