Teledyne 2002 8. 4-20 mA Interface Option Board, Model Rear Panel Detail, 8.1. 4-20 mA

8. 4-20 mA Interface Option Board

The Relay option board in the Model 2002 operates off of the set points defined by the user and programmed into the Model 2002 microprocessor. For more information about configuring these set points refer to Section 3 of this manual.

The 4-20 mA interface board is available as an option for the Model 2002. This board provides dual current channels linearly proportional to the HPM 2002’s pressure reading. Please note that use of the Model 2002 with this option requires a CPU with firmware for version 1.6 or later.

Model 2002

Rear Panel Detail

Fig 8.1

8.1. 4-20 mA	Interference
Connector Pin Assignments
Pin	Connection
1	Internal loop power out (+) channel 1.
3	Loop in (-) channel 1.
8	Internal loop power out (+) channel 2.
7	Loop in (-) channel 2.

The 4-20 mA board can only be operated with internal loop power.

A schematic (Figure 8.2) is attached to show the proper method to wire into a loop.

Symptom: Fixed display, regardless of pressure

Action: 1. Check sensor for contamination.

149-072011 Model 2002 Vacuum Gauge Page 29 of 38