Model 3000 | Quickstart Guide |
|
|
Electrical Connections
CAUTION: READ ALL SAFETY INFORMATION REGARDING ELECTRICAL HAZARDS ASSOCIATIED WITH THIS INSTRUMENT BEFORE MAKING ELECTRICAL CONNECTIONS.
CAUTION: POWER IS APPLIED TO THE INSTRUMENT'S CIRCUITRY AS LONG AS THE INSTRUMENT IS CONNECTED TO THE POWER SOURCE. THE RED SWITCH ON THE FRONT PANEL IS FOR SWITCHING POWER ON OR OFF TO THE DISPLAYS AND OUTPUTS ONLY.
•Connect primary input power:
Insert the power cord into the power cord receptacle.
•Install the fuse:
Fuses are not installed at the factory. Be sure to install the proper fuse as part of installation.
Place small screwdriver in notch, and pry cover off, as shown in the figure.
To change between American and European fuses, remove the single retaining screw, flip fuse block over 180 degrees, and replace screw.
Replace fuse as shown below. Reassemble Housing
Teledyne Analytical Instruments | 5 |
