Phonecell SX4D Programming - continued

Exit Programming Mode

The programming mode can be exited by any one of the following:

1.Go “off-hook” (pick up handset)

2.Failure to enter the correct password three times (technician mode only)

3.Failure to enter any digit within two minutes.

The PM (Programming Mode) icon is then turned off, returning the Phonecell SX4D to the Normal Mode.

Phonecell SX4D User-Programming Commands

The following commands are displayed when in the user programming mode. An <entered value> is comprised of the digits 0 through 9.

How to Enter Call Alert Volume

The following key sequence is used to enter the volume of the call alert:

Label: CALL ALERT VOL

Data: <volume>

The volume value is set to 0 for off; 1 for low; and 2 for high. If the volume value is greater than 2, it is considered invalid. The factory default is 2.

Enter Auto Send Delay

The following key sequence is used to enter the auto send delay:

Label: AUTO SEND DELAY

Data: <delay>

If the delay is not in the range of 2 to 20 seconds, it is considered invalid. The factory default is 3.

Enter RSSI Display Type Option

The following key sequence is used to select the RSSI display option:

Label: RSSI DISPLAY

Data: <type>

The type value is set to 0 for direct readout in dBm or 1 for bar graph. If the RSSI display type value is greater than 1, it is considered invalid. The factory default is 0.

Enter LCD Display Contrast

The following key sequence is used to enter the LCD Display Contrast:

Label: LCD CONTRAST

Data: <contrast>

If the LCD contrast is not in the range of 0 (darkest contrast) to 19 (lightest contrast), it is considered invalid. The factory default is 10.

Enter Zero-Delay Dial

The following key sequence is used to enter the Zero Delay Dial option:

Label: ZERO-DELAY DIAL

Data: <zero-delay dial>

The zero delay dial value is set to 0 for Disable and 1 for Enable. The factory default is 1 (Enable).

SX4D GSM 900 • SX4D GSM 1800

31

USER MANUAL

Page 32
Image 32
Telular user manual Phonecell SX4D Programming, Phonecell SX4D User-Programming Commands