The amount of storage allocated to each Fibre Channel port may be changed using a simple configuration utility provided in the monitor. To enter this utility, type ‘partition’ on the monitor command line. You should see a message similar to this one:
**
Command (h for help):
To see a list of the available commands, type ‘h’ at the prompt.
Command (h for help): h a add wwn to LUN Mask
ddelete wwn from LUN Mask l link an fc port to LUN p print the LUN table
q quit without saving changes r resize LUNs
u unlink an fc port from LUN
w write changes to flash and exit
Command (h for help):
Using the ‘p’ command, you can view partition information for either a single port or the entire
Command (h for help): p
Enter the LUN number
ports: 5
access: Open access LUN 2
ports: 9
access: Open access Command (h for help):
4.3.1 A Worked Example on Changing the RAM-SAN Configuration
The following sections detail how to change size of the LUNs within the system. We will change the factory configuration that is explained above. The new configuration will consist of three LUNs and have LUN masks that allow only four host machines to access the
For the sake of discussion, we will assume we have four HBAs connected to the same fabric that the
The new configuration will consist of three LUNs that are accessed using two Fibre Channel ports in the
The goal of the example is to create the following configuration:
Texas Memory Systems, Inc. (February 7, 2003) |
