Therma-Tru Hinged Patio Door System Single Panel Assembly Unit manual Flange Installation

Models: Hinged Patio Door System Single Panel Assembly Unit

1 16

Page 11

Inswing

Outswing

NOTE: Inswing application shown.

Center top flange into head jamb kerf and press into place using a rubber mallet if necessary.

Align edge of side flange with bottom of side jambs.

Firmly press into kerf in jamb using a rubber mallet if necessary.

Flange will be set back approximately 1/2” from top edge of jamb.

Image 11

Contents

PATIO DOOR SYSTEMS Read all instructions before startingSingle Panel Unit Assembly Therma-Tru Hinged Patio Door SystemDoor Bottom Inswing Door Panel Door Bottom Tools/materials required Part identification - continuedAlign and Install Hinges REMOVE COMPONENTS FROM PACKAGINGATTACH HINGES TO DOOR Standard Hinge OptionAttach hinge to door INSTALL DOOR BOTTOMAdjustable Hinge Option ATTACH HINGES TO DOOR - continuedHinge Jambs INSTALL WEATHERSTRIPApply Weatherstrip to Active Frame Parts Head JambsSlide Strike Assembly onto Lock Jamb INSTALL STRIKESStandard Strike Option - Inswing Multi-pointLock OptionFasten Hinges to Hinge Jamb ATTACH HINGES TO JAMBStandard Hinge Option Apply End Seal Pads 7 FRAME ASSEMBLYInswing Sill Option Fasten Side Jambs to Head JambCaulk Entire Sill Gain FRAME ASSEMBLY - continuedOutswing Sill Option Partially Set Sill Screws in JambsFlange FLANGE INSTALLATIONInstall Top Flange Align and Install Side FlangesPlace Door into Frame DOOR INSTALLATIONStandard Hinge Option Make 2 “Insert Skids”Engage Hinge Knuckles DOOR INSTALLATION - continuedAdjustable Hinge Option Install Hinge PinsAttach Transport Clip to Door ATTACH TRANSPORT CLIPStandard Lock Option Multi-pointLock OptionAttach Transport Clip to Door UNIT READY FOR INSTALLATIONATTACH TRANSPORT CLIP - continued See “Unit Installation” instructionsAIHPSNGL PATIO DOOR SYSTEMS2004 Therma-TruCorp 03-01-04