Therma-Tru Smooth-Star manual Insert Panel Bumper, Handle Installation, Attach Strike Plate

20

INSERT PANEL BUMPER

Insert panel bumper into first channel from interior in head jamb, butting end of bumper against stationary side jamb. Seat panel bumper flush

with head jamb.

Head Jamb

Interior

	Exterior
	Panel
Side Jamb	Bumper

NOTE:

If needed, bumper can be cut down from its original length of 6" to 4 ½". This will allow for a wider entrance.

21

HANDLE INSTALLATION

Refer to instructions supplied with handle set kit.

22

ATTACH STRIKE PLATE

Align slots in strike plate to pre-drilled holes in active side jamb and fasten with

(3) #8 x 1 3/8" flat head screws.

Close door and adjust strike plate for proper latch engagement.

Latch throw can be adjusted by the slotted adjustment screw on the face of mortise lock.

Pre-drill (4) 3/32" dia. pilot holes through each screw hole of the strike plate into the jamb.

Drive (4) #8 x 1 3/8" flat head screws through the screw holes of the strike plate into the jamb as shown.

13