Apply Silicone Sealant to Sill and Fins

APPLY SILICONE SEALANT TO SILL AND FINS

Run continuous beads of sealant across entire length of sill bottom and around entire perimeter of backside of sealing fin to provide a weather-tight seal.

Sealant

NOTE:

CONTINUOUS BEADS OF

SEALANT ARE REQUIRED.

SET UNIT INTO ROUGH OPENING

Exterior

From outside of house, set system into rough opening. Apply pressure on sill to set sealant.

Page 8

Image 8

Therma-Tru Smooth-Star, Fiber-Classic manual Apply Silicone Sealant to Sill and Fins, SET Unit Into Rough Opening

Contents

Double Unit Assembly & Installation Screen sold separately Active Panel Inactive Panel Screw Chart LAY Frame Components Onto Work Area If APPLICABLE, Install TOP-HUNG Screen TrackInstall Sill CAP Base Attach Sill to Jambs Attach Head to Jambs Drip CAP Installation Apply Corner Pads to Sealing FIN Frame Installation Apply Silicone Sealant to Sill and Fins SET Unit Into Rough Opening Level Sill Plumb Side Jambs Secure Frame in Rough Opening Apply Sealant to Inactive Door Riser Install Stationary Panel Install Anchor Blocks Install Active Panel Adjust Rollers Install Active Interlock Attach Inactive Interlock Attach Strike Plate Handle InstallationInsert Panel Bumper Attach Foot Bolt Install Sill CAP TOPPrep Door for Foot Bolt Install Foot Bolt Keeper Insert PlugsAttach Jamb Cover Sliding Screen Door Active panel edge Dia holes 1 deep Towards Page Finishing Instructions WEATHERPROOF, Finish and Maintain Jamb Extension Information Interior Casing Attachment Sizing Information Door Handing Guide Patiodoorsystems

Therma-Tru Smooth-Star manual Apply Silicone Sealant to Sill and Fins, SET Unit Into Rough Opening

Models: Fiber-Classic Smooth-Star

APPLY SILICONE SEALANT TO SILL AND FINS

SET UNIT INTO ROUGH OPENING