3. Preparing the appliance
qRemove the side brackets and fixing plates which attach the furniture fronts.
To do this, loosen the fastening screws and remove the stop parts.
iStore the stop parts in suitable receptacles, otherwise they may get lost.
4. Preparing the installation cavity
i2 antitipbrackets are required for each appliance or appliance combination (SidebySide).
qSpecify the attachment points of the antitipbrackets.
Specify the detailed dimensions according to the section on •Installation dimensions" starting on page 8.
d WARNING d
Assure that there are no electrical wires or plumbing in the area which the screws could penetrate - risk of injury and damage!
qIf the installation cavity is deeper than the appliance, place a solid wooden beam behind the antitipbrackets and attach securely to the base or the wall.
The length of the wooden beam is equal to the width of the installation cavity!
! IMPORTANT NOTE !
If possible, always screw the wooden beam to existing studs on the rear panel of the cavity.
In some installations the subflooring or finished floor may necessitate angling the wood screws used to fasten the antitipbrackets to the back wall.
iImportant information for secure attachment of the antitip brackets:
-The supplied set contains fastening screws for various applications. Select the fastening screws according to the local conditions.
-If the supplied fastening screws do not permit secure attachment of the antitip brackets and therefore the appliance, another method must be used to attach the antitip brackets securely.
13