
qPrevent the power cord from becoming caught.
Tie a piece of string to the middle of the power cord and feed forwards under the appliance. When pushing in the appliance, pull the cable forwards.
or
Using adhesive tape, stick the power cord to the floor centrally behind the appliance approx. 15" (380 mm) away from the rear panel of the cavity.
qCarefully push the appliance into the cavity until the heightadjustable wheel interlock with the antitip brackets.
10.Installing and aligning the appliance
|
| q Align the appliance with the furniture fronts. | ||
|
|
| Place markingout level over the installation aid | |
|
|
| parts on the door. | |
|
|
|
| |
|
| i | The installation aid parts on the door have been | |
|
|
| designed for the following total thickness of furniture | |
|
|
| doors: | |
|
|
| - ¾" (19 mm) | |
q Remove edge protection. | ||||
- 1½" (38 mm) | ||||
|
|
| Always take account of the possible differing |
thickness of the furniture fronts which are to be fitted subsequently.
The heightadjustable feet at the front and rear can all be adjusted from the front.
Front: | with openended wrench 1/2" (SW13) |
Rear: | with 5/16" (8 mm) hex nut driver |
| via flexible shaft. |
A mark is attached to the appliance base and is used as a standard gage for height adjustment. When adjusting the height, align this mark at a height of 1¼" (32 mm) above the floor.
17