Installation options
There are many different installation options.
These are limited only by the design of the kitchen and the function of the finger guard.
Individual unit
Side0by0Side
* | * |
*Partition required!
iWhen 2 appliances are installed SidebySide,
the Basic Combination Side0by0Side Sealing kit •BSEALKIT10" must be used to ensure a stable connection.
When combining 2 appliances with a freezing function (e.g. 2 freezers or 1 bottom mount appliance and 1 freezer), use the Extreme Combination Side0by0Side Heating kit •XHEATKIT10".
See the section on •Optional accessories" on page 11.
Individual appliances with partition
1.2.
3.4.
iNote
-When dimensioning the partition for model 4, note the thickness of the furniture fronts to prevent damage if the doors are opened at the same time.
-Use the Extreme Combination Side0by0Side Heating kit •XHEATKIT10"
a)If the gap between the appliances is less than 6" (160 mm),
b)for permanent connection of two individual appliances, e. g. Freezer or Bottom Mount appliance next to Freezer.
See the section on •Optional accessories" on page 11.
-Minimum thickness of the partition 5/8" (16 mm).
At the end of the kitchen units
If one side of the appliance is visible, a side panel must be used.
The side panel must be connected firmly to the wall, the floor and overhead furniture/fixtures before the appliance is placed in the cavity.
The dimensions of the side panel are taken from the opposite cavity wall. During installation ensure that the cavity is square and the exact size.
5