Belts, Controls and Linkages
15.Reinstall (2) screws that secure auger brake arm assembly. Make sure tabs fit into holes in left side of machine (Figure 48).
|
|
Figure 48 |
1. Tabs in holes
16.While someone squeezes the auger/impeller control lever (Figure 49) against the handgrip, reinstall belt guide using (2) screws, (2) washers, and (2) lock washers removed previously. Check and readjust belt guide, making sure it does not contact any part of the engine pulley.
|
|
|
|
|
|
| Figure 49 | ||
1. | Auger/impeller | 3. | Speed selector | |
| control lever | 4. | Discharge chute | |
2. | Traction control lever | control | ||
17.Check and adjust auger drive linkage. Refer to steps
18.Reinstall idler pulley spring.
19.Reinstall belt cover with (3) screws.
20.Make sure that auger and impeller are not rotating when auger/impeller control lever is disengaged. While standing in the operator position behind the handles, look around to the side of the auger housing. If the auger and impeller are rotating, a large screw head on the side of the auger housing will be rotating (Figure 50). If the auger and impeller are rotating when the engine is running and the auger/impeller control lever is not engaged, immediately stop the unit. Refer to "Adjusting Auger/Impeller Drive Belt" on page 2 - 7.
IMPORTANT: Do not operate unit if auger and impeller rotate when auger/impeller control lever is not engaged.
|
|
Figure 50 |
1. Large screw head
2 - 6 | Two Stage Snowthrower Drive Systems Manual |
