Reelmaster 4000–D Page 5 – 33 Electrical System (Rev. A)
Rear Wheel Drive Solenoid Replacement
Figure 28
1. Disconnect solenoid electrical connector.
2. Remove nut from solenoid.
3. Remove solenoid coil.
4. Install new solenoid coil. Make sure o–ring is
installed at each end of coil. Apply ”Loctite 242” or equiv-
alent to threads on end of valve stem before installing
nut. Tighten nut to a torque of 15 in–lb (17.3 kg–cm).
Over–tightening may damage the solenoid or cause the
valve to malfunction.
5. Connect wiring connector.
Figure 29
Electrical
System