Toshiba 51H93 owner manual Link connection, To connect to the G-LINK jack, See

Chapter 2: Connecting your TV

G-LINK connection

This connection is necessary to enable the TV Guide On Screen™ system’s device control and one-touch recording features.

After you connect your devices to the TV (pages 12–24), you will need to connect the G-LINK cable (one of the dual-wand IR blaster cables included with your TV) from your VCR and Cable box (if applicable) to the G-LINK jack on the TV. This connection is necessary to enable the following features of your TV Guide On Screen™ system:

•If you have a Cable box, you need to connect the IR blaster cable from the Cable box to the G-LINK jack to receive the TV Guide On Screen system’s program listings for your Cable service.

•If you have a VCR, you need to connect the IR blaster cable from the VCR to the G-LINK jack to use the TV Guide On Screen system’s one-touch recording feature.

To connect to the G-LINK jack:

1.Locate the infrared sensor on the front of your VCR or Cable box. The sensor is marked on some devices.*

2.Align one of the G-LINK (IR blaster) cable’s wands about 1 inch away from the infrared sensor on the front of the VCR and attach it using the included mounting tape.

If you have a Cable box, attach the other wand in a similar manner. (See illustration at right.)

Note: If you do not have a Cable box, coil the second wand with a rubber band and leave it behind the TV.

3.Plug the G-LINK (IR blaster) cable’s plug into the TV’s G-LINK jack.

For details on setting up the TV Guide On Screen system:

Front of Cable box

Front of VCR

Infrared sensor

G-LINK (IR blaster) cable wand (approx. 1 inch from device)

See page 36.

For details on using the TV Guide On Screen interative program guide:

See page 53.

*If you cannot locate the device’s infrared sensor:

Back of TV

ANT( 75	)	G-LINK
			DVI/HDCP IN	TheaterNet
				IEEE1394
				1
ANT-1	ANT-2
				IEEE1394
	REC OUT			2
VIDEO	L	R		DIGITAL
	AUDIO			AUDIO OUT

IN

1. Turn OFF the device.

2.Starting at the lower left corner of the device, place the end of the device’s remote control (with the infrared emitter) so it touches the front of the device and press POWER. (Do not use the TV’s remote control for this step.)

3.If the device turns on, the place the remote control touched the device is the location of the sensor.

4.If the device does not turn on, move the remote control slightly to the right and press POWER again.

5.Repeat step 4 until you locate the device’s infrared sensor.

VIDEO 1 VIDEO 2

S-VIDEO

VIDEO

L/

MONO

AUDIO

R

COLOR	COLOR
STREAM	STREAM
HD-1	HD-2

Y	Y		AUDIO
		R	L
PB	PB
		OUT	AUDIO CENTER
PR	PR	VIDEO	CHANNEL IN
		L/
L	L	MONO	L	TheaterNet
AUDIO	AUDIO	AUDIO	VAR
			AUDIO	ON OFF
R	R	R	R	IR OUT

Copyright © 2003 TOSHIBA CORPORATION. All rights reserved. 25