Toshiba 51H93 Adjusting the color convergence, Manually adjusting the color, Convergence

Chapter 6: Setting up your TV

Adjusting the color convergence

This projection TV uses three separate image tubes: red, green,				Manually adjusting the color
and blue. The red, green, and blue images are projected onto the				convergence
screen where they converge to form a full-color picture. You can
see a clear picture only when the three images converge correctly.				To check and adjust the color convergence manually:
Convergence may drift over time or if you move the TV. If you
				1. Press MENU and open the SETUP menu.
can see clear images on your TV screen, skip this procedure.
				2. Highlight CONVERGENCE and press ENTER.
This adjustment should be made only after the TV has been on
for at least 30 minutes.
Automatically adjusting the color
						Setup
convergence using TouchFocus™						Installation
						Sleep Timer
To automatically adjust the color convergence:						On/Off Timer
						Digital Tuner Hold • • • • • • • Off
	Press TouchFocus on the TV front panel one time.					Slide Show Interval • • • 2 Sec
						Convergence
	TV front panel
				3. The center convergence adjustment window (below) opens.
					If you see separate red, blue, or green crossed lines (or red
					or blue shadows next to white lines), you need to adjust the
		MENU VOLUME CHANNEL EXIT TV/VIDEO TouchFocus
					convergence.
			TouchFocus

The TV will enter the auto convergence mode.

BLUE

RED

: TO ADJUST

Horizontal

ENTER : TO SELECT COLOR

EX I T

: TO SELECT

POSITION

TOUCH FOCUS

B

R

G

4. Press ENTER to highlight RED or BLUE, depending on

which color needs adjusting. If both red and blue need

adjusting, you will need to perform steps 4 and 5 twice.

Vertical

5. Press y (up), z (down), x (left), or • (right) on the

remote control to converge the red or blue lines into the

TOUCH FOCUS F I N I SHED

white line. When color convergence is correctly adjusted,

you will see two single crossed white lines.

6. Press EXIT to display the Circumference Convergence

When adjustment is complete, the normal picture will

menu.

7. Press the corresponding Number button (1–4 and 6–9) to

reappear.

select the area you want to adjust.

If the error message “Touch Focus Error” appears, retry the

TouchFocus adjustment or adjust the convergence

1

2

3

manually, as described at right.

4

6

PUSH

1 – 9

7

8

9

50 Copyright © 2003 TOSHIBA CORPORATION. All rights reserved.