Toshiba 6520c, e-STUDIO5520C manual Change the paper type as required, Place paper on the left tray

1 BEFORE USING EQUIPMENT

yPaper in the right-hand tray is used first. When it runs out, paper in the left-hand tray will be moved automatically to the right-hand tray and fed.

yA maximum of 2360 sheets (80 g/m2) (20 lb. Bond) can be placed in the 2 trays. However the stack height of the paper must not exceed the line indicated inside the side guides.

P.11 “Acceptable copy paper”

yThe copy side may be noted on its wrapping paper.

yBe careful not to cut your fingers when fanning the paper.

yWhen placing paper, be sure that the center lever is not open. (See the label attached in the Tandem Large Capacity Feeder.)

3 Push the drawer of the Tandem Large Capacity Feeder straight into this equipment carefully.

When the drawer is completely inserted, the right-hand tray will move up to the paper feeding position.

Do not slam the drawer shut. Stacked sheets may collapse and they cannot be transported correctly.

Be careful not to let your fingers be caught when pushing the drawer into this equipment.

This could injure you.

4 Change the paper type as required.

P.19 “Setting paper type”

‰Adding paper in the Tandem Large Capacity Feeder during copying

When the paper on the left tray of the Tandem Large Capacity Feeder has run out during copying, “Paper for left drawer can be added.” appears. You can pull out the Tandem Large Capacity Feeder and add paper to the left tray without stopping copying. This is useful when you wish to make a large amount of copies quickly.

1	Pull out the drawer of the Tandem Large Capacity
	Feeder carefully until it comes to a stop.
	Only the left tray will come out.	A
	Do not touch the slide rail (“A” in the figure on the right).
	This could injure you.

2 Place paper on the left tray.

Place paper aligning to the left-hand side of the tray.

22 Placing Paper